![]() So we have to assign the clock rate here) Router(config-if)# no shut (Enable the serial port s0/0) Router(config-if)# int f0/0 (Selecting Fast Ethernet f0/0) Router(config-if)# ip add 10.0.0.1 255.0.0.0 (Adding IP Address to the Fast Ethernet port f0/0) Router(config-if)# no shut (Enable the Fast Ethernet port f0/0) Add IP Address to the Router 2 Router> en (Enable Privilege Mode) Router# conf t (Enable Global Configuration Mode) Router(config)# int s0/0 (Selecting serial port s0/0) Router(config-if)# ip add 20.0.0.1 255.0.0.0 (Adding IP Address to the serial port s0/0) Router(config-if)# clock rate 64000 (Hence, the DCE side of the serial cable is connected to the Router 1. The first step to configure static routing on a router is to add the IP Address to all required port of the router and assign the clock rate on the DCE side of the serial cable. How to configure static routing in 2 routers on packet tracer It is a one-way communication and here we do not use any routing protocol. Static Route is the route that the network administrator manually enters into the routing table. Before that, let’s understand what does the static routing means. In this post, I am going to show you how to configure static routing in 2 routers on packet tracer and with that, I will also share you all the important static routing commands and its uses. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |